Shure PGX24/SM58

Complete hand held radio mic system including PGX24 receiver and SM58 handheld transmitter.

Shure PGX Wireless Systems - PGX24/SM58 - Complete System including receiver and SM58 handheld transmitter. The Shure PGX Series wireless microphone systems combine the convenience of single touch remote channel setup with the reliability of a diversity UHF design. Created for active musicians and presenters who also manage their own sound, Shure PGX Wireless improves your performance and simplifies your setup. Innovations such as automatic frequency selection and automatic transmitter setup make wireless quicker and completely worry-free. Channel and frequency settings are remotely synchronized from the transmitter to the receiver via infrared. PGX systems now feature Shure’s patented Audio Reference Companding, delivering the crystal clear sound quality that pro audio engineers trust. The PGX24/SM58 Handheld System is ideal for vocal use in stage performances, presentations, television, broadcasting, video, film, and sound reinforcement. This system includes the PGX4 receiver, PGX2 handheld transmitter with SM58 microphone capsule, clip and case. The PGX4 receiver operates over an 18MHz UHF bandwidth (846 - 865 MHz) with the flexibility of selecting up to 90 UHF frequencies. It is possible to run 9 of these systems simultaneously with their own channel selections. The diversity design enables dual internal receiver circuits to compete for the strongest possible reception, minimising noise and RF interference. The rear panel has both XLR and 1/4 inch phone outputs. The PGX2 handheld transmitter includes the SM58 cardioid microphone head. The cardioid polar pattern reduces pick up at the off-axis sections of the capsule, reducing noise and providing higher gain-before-feedback response. A 2-position input level switch adjusts input level and reduces noise if the signal overloads. The transmitter operates up to 8 hours on 2 AA-size batteries. PGX24/SM58 Features: SM58 frequency response tailored for vocals, with brightened midrange and bass roll-off The Frequency Agile UHF design provides up to 90 selectable UHF frequencies that operate on an 18MHz UHF bandwidth Diversity Reception system uses twin receiver circuits to minimise noise and drop out caused by RF interference Hi-quality sound with quick and easy setup using infrared remote synchronization of channel and frequency status Use 9 systems simultaneousy within the 846 - 865 Mhz range for big events PGX4 has XLR and unbalanced 1/4 inch jack audio outputs PGX2 includes mute switch and battery power warning lights - 8 hours battery life from 2 x AA 1.5v alkaline batteries Rugged carry case and batteries and mic clip included with this microphone SM58 Specifications: Type: Dynamic (moving coil) Frequency Response: 50 to 15,000 Hz Polar Pattern: Unidirectional (cardioid), rotationally symmetrical about microphone axis, uniform with frequency Sensitivity (at 1,000 Hz Open Circuit Voltage): –54.5 dBV/Pa (1.85 mV) 1 Pa = 94 dB SPL PGX System Specifications: Working Range: 100m (300 ft.) Note: actual range depends on RF signal absorption, reflection, and interference Audio Frequency Response +/– 2 dB: Minimum: 45 Hz, Maximum: 15 kHz (Overall system frequency depends on microphone element.) Total Harmonic Distortion (Ref. +/– 33 kHz deviation, 1 kHz tone): 0.5%, typical Dynamic Range: 100 dB A-weighted Operating Temperature Range: –18 degrees C (0 degrees F) to +50 degrees C (+122 degrees F) Note: battery characteristics may limit this range Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output PGX2 Specifications: Audio Input Level: +2 dBV maximum at -10dB position, -8 dBV maximum at 0dB position Gain Adjustment Range: 10dB RF Transmitter Output: 30 mW maximum (dependent on applicable country regulations) Dimensions including SM58 cartridge: 254 mm x 51 mm dia. (10 x 2 in.) Weight: 290 grams (10.2 oz.) without batteries Housing: Moulded PC/ABS handle and battery cup Power Requirements: 2 AA size alkaline or rechargeable batteries Battery Life: Around 8 hours (alkaline) PGX4 Specifications: Dimensions: 40 mm H x 181 mm W x 104 mm D (1.6 x 7.125 x 4.1 in.) Weight: 327 g (11.5 oz.) Housing: ABS Audio Output Level (Ref. +/– 33 kHz deviation with 1kHz tone): XLR connector (into 600 Ohm load): –19 dBV, 1/4 inch connector (into 3000 Ohm load): –5 dBV Output Impedance: XLR connector: 200 Ohm, 1/4 inch connector: 1kOhm XLR output: Impedance balanced, Pin 1: Ground (cable shield), Pin 2: Audio, Pin 3: No Audio Sensitivity: –105 dBm for 12 dB SINAD, typical Image Rejection: 70 dB, typical Power Requirements: 12–18 Vdc at 150 mA, supplied by external power supply

Shure PGX24/SM58 @ Electro Music.
Price: £339.00.